Parts needed[u
1 - Mohm resistor
1 - 1µF capacitor
wire
Soldering iron
solder
Electrical tape
*film canister (I used this to hold the simulator and to keep it dry you can use whatever)
1.) get your supplys and your old o2 sensor
2.) cut your wire. I stripped the end then cut another section and slid the caseing up.
3.)Now Solder in your resistor and capacitor
4.) tape up each side so nothing can touch and ground out.
5.) poke some holes in your film can (or make a place for the wires in whatever you use)
6.) Feed the wires through the holes in the film can and put the simulator insidethe film can ( you may have to tweak a little to make it fit)
7.) Tape up film can (to keep water out)
8.) now get out your O2 sensor! the white wires are your heater (DO NOT CUT THESE!!!) you will be cutting the black and grey (signal wires) (yours may be diffrent so double check) than splice your simulator in to the side connected to the plug. (the sensor side is now dead so you can tape it or leave it)
9.) tape up and you are done!
I use this with a hallow cat and have had no problems for over 100 miles
[/u]
