I'm going to a parts car that has a trunklight installed. My Neon currently does NOT have one.
Can anyone recommend what I'll need (both equipment and procedure) to remove the trunk light from the parted out Neon and install it in my Neon?
Moving a Trunk Light Switch/Assembly From One to Another
-
- 1GN n00b
- Posts: 2
- Joined: Wed Feb 25, 2009 4:21 pm
- Location: New York
Re: Moving a Trunk Light Switch/Assembly From One to Another
You are going to need the third brake light harness, trunk latch and the light that snaps in the hole and as much of the harness with the plug you can get all from the donor Neon, some Neons are wired for trunk light and all you do is install the latch and third brake light harness, find the trunk light connector under package tray and snap in light and plug in and done, if not pre wired this is where the light harness you cut off the donor comes in handy, one side of the light gets a constant 12volts from the dome light wiring which is under the right rear sail panel trim and the latch grounds it......Here is a diagram that should help......
ReverendRed wrote:I'm going to a parts car that has a trunklight installed. My Neon currently does NOT have one.
Can anyone recommend what I'll need (both equipment and procedure) to remove the trunk light from the parted out Neon and install it in my Neon?
1995 Plymouth Strawberry 4 door was SOHC ATX with now a full 98 R/T DOHC MTX everything swap front to back ....300,000 miles on 95 before being reborn as a 98 R/T with 68,000 miles.
http://www2.cardomain.com/ride/779073
http://www2.cardomain.com/ride/779073