have a few problems
speedometer is messed up it is telling me the wrong speed but my tach is right...
my girlfriends neon has a left turning signal when breaking and 4ways at anything over 120km...
and not sure if this is going to be in the right catagory if not can i have some direction on where to post this
i have 2 codes
P0108 manifold absolute pressure/ BARD sensor high input
P0113 intake air temperature sensor 1 circuit high input
what should i do
issues help speedo lights and codes
-
- 1GN Registrant
- Posts: 19
- Joined: Wed Jun 06, 2012 7:19 pm
- Location: Ottawa ON
issues help speedo lights and codes
Red for now , expresso, cold air intake, shaft and knife mod, chipped ...
-
- 1GN Registrant
- Posts: 19
- Joined: Wed Jun 06, 2012 7:19 pm
- Location: Ottawa ON
Re: issues help speedo lights and codes
Cant help with anything else but the turn signal coming on when you hit your brakes is a bad multifunction switch. I assume when it does it if you just barely tap up on the turn signal lever it goes away. Also if its like when mine was messed up, when I hit my brakes and the left turn signal would light up the brake light on the left side would not work.Expresso97 wrote:have a few problems
speedometer is messed up it is telling me the wrong speed but my tach is right...
my girlfriends neon has a left turning signal when breaking and 4ways at anything over 120km...
and not sure if this is going to be in the right catagory if not can i have some direction on where to post this
i have 2 codes
P0108 manifold absolute pressure/ BARD sensor high input
P0113 intake air temperature sensor 1 circuit high input
what should i do
1995 Highline Coupe SOHC MTX.
DOHC Mopar PCM
e85, 30lb injectors, LM-1, SAFC
Custom CAI, 60mm MPx TB, AMM Box Intake, DOHC pistons, built4race UDP
PT Clutch, 3.94 FD
AF/X LTH, High Flow Cat, Spiral Flow, 2.5" piping, Flowmaster 80 series
P&P Magnum head, Crane springs, Crane 007, AEM 3-bolt cam gear almost ready to bolt on
DOHC Mopar PCM
e85, 30lb injectors, LM-1, SAFC
Custom CAI, 60mm MPx TB, AMM Box Intake, DOHC pistons, built4race UDP
PT Clutch, 3.94 FD
AF/X LTH, High Flow Cat, Spiral Flow, 2.5" piping, Flowmaster 80 series
P&P Magnum head, Crane springs, Crane 007, AEM 3-bolt cam gear almost ready to bolt on
-
- 1GN Registrant
- Posts: 19
- Joined: Wed Jun 06, 2012 7:19 pm
- Location: Ottawa ON