Adjusting rear-wheel camber

uta_flyinghigh · Post by **uta_flyinghigh** » Thu Mar 06, 2008 4:27 am

...how can it be done ?

UTA

afireinside4848 · Post by **afireinside4848** » Thu Mar 06, 2008 8:38 am

I'm not sure but my right rear tire is bent slightly in and rubbing on the one arm. Not good. I think you need adjustable struts for this.

98moparR/T · Post by **98moparR/T** » Thu Mar 06, 2008 9:21 am

thank dodge for this one, I believe it can't be done with out slotted struts like konis or coil overs

DOHCRT · Post by **DOHCRT** » Thu Mar 06, 2008 5:45 pm

Slot the struts. Very easy task. You can also buy eccentric bolts.

robert 'bob' paulson · Post by **robert 'bob' paulson** » Fri Mar 07, 2008 1:19 am

DOHCRT wrote:You can also buy eccentric bolts.

Eibach Alignment Kits

NeonDriven95 · Post by **NeonDriven95** » Fri Mar 07, 2008 10:43 pm

id just slot the struts

robert 'bob' paulson · Post by **robert 'bob' paulson** » Fri Mar 07, 2008 11:45 pm

NeonDriven95 wrote:id just slot the struts

have you previously done it?

afireinside4848 · Post by **afireinside4848** » Sat Mar 08, 2008 12:27 am

Hit a curb? lol

uta_flyinghigh · Post by **uta_flyinghigh** » Sat Mar 08, 2008 5:01 am

Given that messing up with my car would involve a trip to the USA, I think I'll leave the struts alone

UTA

TomZ · Post by **TomZ** » Sat Mar 08, 2008 11:19 am

You can use the camber bolts, but you sacrafice some bolt strength. Slotting the struts isn't hard, a dremel, or metal cutting burr on an air tool, and some patience is all it takes.

JaxMadine · Post by **JaxMadine** » Wed Aug 27, 2008 9:38 pm

uni-drill bit! one size fits all!

farmboy · Post by **farmboy** » Sat Dec 13, 2008 4:30 pm

are there not rear lower adjustable control arms for 1gns like there are for 2gn's? i saw LilSparkPlug on 2gn got a set of these for her SRT and they allow for rear camber adjustment? would there be something like that for our 1gn's too? (her's are through Mopar...)

metal_gear_jon · Post by **metal_gear_jon** » Sat Dec 13, 2008 8:03 pm

My replacement Sensatracs had the upper hole sloted, so it all depends on the manufacture of the strut.