This is the place to ask questions about your engine components like cams, valves, pistons? just anything that is generally "engine" specific.
3 posts • Page 1 of 1
Ok I was wondering if neone has ever had a problem like this. I took my car to the car wash and used the engine cleaning part of it, neway i was driving home and my car sputtered once i was like ok a burp. like when ur spark plugs go out. So neway i get home sit for a lil bit and then I went out again well this time it was way worse. i stopped at a gas station and looked down in the engine bay and seen smoke comming from the back of it. i looked back there and i seen oil all over the ground. neway i was wondering if neone has had this problem when there crank position sensor went bad with oil leaking and car sputtering.
96 slow dumb and stupid.
I had a similar problem with my sensor. I'm only geussing but it sounds like when you washed your engine, the o-ring was damaged. The sensor is a sealed unit. so I would try replacing the o-ring and cleaning the connector. Check also that your sensor is not cracked because that will cause an oil leak and LOTS of smoke. Good Luck!!
If at first you don't succeed, you're about average!!