Page 1 of 1

coolant + intake manifold

Posted: Sat May 26, 2007 1:51 am
by phillyplayer3000
coolant coming out of intake manifold.. might have a crack in the head help suggestion

Posted: Sat May 26, 2007 9:56 am
by chipdogg
DOHC? Coolant passes through manifold on passenger side of car towards front of engine. Intake manifold gasket.

Posted: Sun May 27, 2007 11:11 am
by phillyplayer3000
n i got no compression

Posted: Sun May 27, 2007 6:05 pm
by chipdogg
Well that's a bit bigger problem then. No compression on all cylinders or what? You gotta give more info than coolant coming from manifold and no compression.

Posted: Mon May 28, 2007 11:24 am
by phillyplayer3000
full story first engine crank got destroyed so i replace it wit a junkyard motor finally pulled old on n put the new 1 in blown head gasket blowing white smoke like a fat kid loves cake and also leaking from the intake manifold from around the the thermestate housing :lol: but anyways pulled off the head needed to resurface it so got that done put every thing back together to spec's n went to crank ova no compression to any cylinder.... plus when i removed the head number 1 cylinder was completely cleaned ...

Posted: Mon May 28, 2007 12:39 pm
by chipdogg
Does it have valves in it?

Posted: Mon May 28, 2007 12:55 pm
by phillyplayer3000
yea

Posted: Mon May 28, 2007 1:08 pm
by chipdogg
So 0 psi on all 4 cylinders??? You got something seriously wrong, even with a cracked head you'd get SOME compression built up.

Posted: Mon May 28, 2007 5:40 pm
by Whodini
did you break a timing belt and bend all your valves?

Posted: Tue May 29, 2007 3:41 pm
by epatchett82
did you put plugs back in?