1GN.ORG 1GN.ORG
get yer n00b on
 
 Watched TopicsWatched Topics   FAQFAQ  Forum RulesForum Rules   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 GarageGarage   1/4 Mile Table1/4 Mile Table   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Why is an SAFC II such a bad Idea with a Turbo Neon

Goto page 1, 2  Next
 
Post new topic   Reply to topic    1GN.ORG Forum Index -> Forced Induction
View previous topic :: View next topic  
Author Message
mahifish
suck it and fuck it
1GN Registrant


Age: 30
Joined: 24 Jan 2008
Posts: 1040
Location: Mil-Town, Wisconsin

1998 Plymouth Neon

PostPosted: Wed Apr 30, 2008 7:09 pm    Post subject: Why is an SAFC II such a bad Idea with a Turbo Neon Reply with quote

I have read countless threads and have had people backlash on me when I mention using a SAFC to tune my car when I go turbo. I never got a good response as to why. I have tuned 5 or 6 turbo'd cars with a wideband and SAFC.

So my question is Why is a SAFC II not going to work well on a boosted neon?
Back to top
View user's profile Send private message AIM Address
6(sic)6
MILF hunter
1GN Registrant


Age: 33
Joined: 09 Mar 2007
Posts: 496
Location: Huntingdon, PA


PostPosted: Wed Apr 30, 2008 10:14 pm    Post subject: Reply with quote

Dunno, prob most just go with MS. It IS the way to go Smile
_________________
SuperCharged SOHC http://forums.neons.org/viewtopic.php?t=280798&highlight=
Samu wrote:
If you get rid of your 1st gen it will be like the girl that got away. Crying or Very sad
Back to top
View user's profile Send private message AIM Address
DOHCRT
damnstupidshit
1GN Registrant


Age: 36
Joined: 03 Mar 2007
Posts: 1225
Location: Columbus, OH

1998 Dodge Neon R/T

PostPosted: Thu May 01, 2008 3:34 pm    Post subject: Reply with quote

It works ok on a lot of cars, just not the neon. One of the biggest problems is that the more fuel you take away with the SAFC, the more the PCM advances timing. Thats bad for boost. Real bad.

Another issue you run into is trying to get the engine to idle properly with big injectors and stock fuel pressure. In order to do this, you again have to pull fuel with the SAFC. The problem is that the MAP is already reading low kpa, and clamping the voltage lower causes it to be out of range. The PCM will never get a correct barometric pressure reading because of the same problem.

The ideal setup is to use an SAFC in conjunction with an FMU. The FMU will tune the basic fuel needs, while the SAFC can be used to "fine tune". I ran this setup for a while until I switched to MS.
_________________
"Losers always whine about their 'best'. Winners go home and fuck the prom queen"

Project Log
Back to top
View user's profile Send private message  
1fast2liter
mines bigger
1GN Registrant


Age: 36
Joined: 01 Mar 2007
Posts: 1225
Location: Beaver dam, WI

1996 Plymouth Neon

PostPosted: Thu May 01, 2008 7:09 pm    Post subject: Reply with quote

a safc is ideal for a all motor car. but turbo cars with mass flow sensors work the best with them.....when the neion goes in to closed loop ie cruise it uses pre burned maps and ignores the safc... in boost and cruise thats bad. a 1:1 or if you use a rrfpr then you dont really need it just a wideband and a quality rrfpr and say a set of stage 0 injectors. ms would be the best way to go. but a rrfpr and stage 0 injectors would do. this is one area that you dont wanna skimp in.. you mite go boom.
_________________


96 blue coupe sold
96 white 4 door sold
95 blue sport parted out
97 straberrie red coupe sold
95 black base parted out

current drivers
97 dodge ram 1500 5.9 ext cab sport fire engine red. tinted windows cat back exhaust suer chips tune, 1 mephis audio sub

90 audi 80. 400 miles to the tank
2002 custom sportster 90 whp and quick too
Back to top
View user's profile Send private message   Yahoo Messenger
Armstrong57
1GN Registrant


Age: 32
Joined: 15 Feb 2007
Posts: 54
Location: Sarnia, Ontario

1997 Dodge Neon

PostPosted: Thu Aug 14, 2008 7:23 am    Post subject: Reply with quote

SAFC tunes fuel by rpms, not by boost. You want to be able to control fuel as it pertains to boost levels.
_________________
Back to top
View user's profile Send private message MSN Messenger  
mahifish
suck it and fuck it
1GN Registrant


Age: 30
Joined: 24 Jan 2008
Posts: 1040
Location: Mil-Town, Wisconsin

1998 Plymouth Neon

PostPosted: Thu Aug 14, 2008 12:55 pm    Post subject: Reply with quote

Armstrong57 wrote:
SAFC tunes fuel by rpms, not by boost. You want to be able to control fuel as it pertains to boost levels.


I've tuned many boosted cars with an SAFC, it doesnt tune by the rpms you control the amount of fuel pertaining to your AFR. I usually use a wideband and tune it at full throttle. It will run rich when your not at full throttle but its much safer then running lean.
_________________
Back to top
View user's profile Send private message AIM Address
Armstrong57
1GN Registrant


Age: 32
Joined: 15 Feb 2007
Posts: 54
Location: Sarnia, Ontario

1997 Dodge Neon

PostPosted: Thu Aug 14, 2008 2:01 pm    Post subject: Reply with quote

Exactly...full throttle = xxxx rpm. So at that rpm you are pulling x amount of fuel. Has nothing to do with boost levels at all, and that's a pretty poor way to properly tune a boosted car.

Running rich enough not to blow the engine doesn't mean it's done right.
_________________
Back to top
View user's profile Send private message MSN Messenger  
DOHCRT
damnstupidshit
1GN Registrant


Age: 36
Joined: 03 Mar 2007
Posts: 1225
Location: Columbus, OH

1998 Dodge Neon R/T

PostPosted: Thu Aug 14, 2008 5:20 pm    Post subject: Reply with quote

Its basically alpha-n (RPM specific) tuning. The SAFC has no way to tune the difference between 5 pounds of boost and 15 pounds. It adds or subtracts the same amount of fuel regardless of manifold pressure. Since we obviously need more fuel at 15psi than we do at 5psi (at the same RPM, of course), you can see why the SAFC can be less than desirable.

The unit does, however, have the ability to adjust its tables based on throttle position. This is a way to infer manifold pressure at part throttle boost. Not a very accurate way, but it works to some degree.

There have been many people to do the "AFC hack" install. This is just wiring the SAFC up so that the MAP sensor is hooked to the units throttle position input. As manifold pressure changes, the SAFC sees it as a varying throttle position and adjust fuel accordingly. A high MAP reading would make the SAFC switch to the "high throttle" table.
_________________
"Losers always whine about their 'best'. Winners go home and fuck the prom queen"

Project Log
Back to top
View user's profile Send private message  
mahifish
suck it and fuck it
1GN Registrant


Age: 30
Joined: 24 Jan 2008
Posts: 1040
Location: Mil-Town, Wisconsin

1998 Plymouth Neon

PostPosted: Fri Aug 15, 2008 1:18 pm    Post subject: Reply with quote

I've never ran over 7 psi with the safc tune. Worked great for the two months I used it. It wasnt permanent and I still put out 315 hp on a 1.9 GM motor.
_________________
Back to top
View user's profile Send private message AIM Address
Armstrong57
1GN Registrant


Age: 32
Joined: 15 Feb 2007
Posts: 54
Location: Sarnia, Ontario

1997 Dodge Neon

PostPosted: Tue Aug 19, 2008 8:15 am    Post subject: Reply with quote

You can tune the car with the SAFC, and it may be safe enough to run, but it won't be optimal. If you got that much hp tuning with SAFC alone, I'm sure you could get even more (and more stable) with the proper tuning method.

If it's working for you, do it! But all we're saying is that it isn't the most optimal way to do it for a boosted setup Smile
_________________
Back to top
View user's profile Send private message MSN Messenger  
mahifish
suck it and fuck it
1GN Registrant


Age: 30
Joined: 24 Jan 2008
Posts: 1040
Location: Mil-Town, Wisconsin

1998 Plymouth Neon

PostPosted: Tue Aug 19, 2008 12:24 pm    Post subject: Reply with quote

I knew that, thats why I went with MS. I just had a hard time finding out where I could get MS for this motor.
_________________
Back to top
View user's profile Send private message AIM Address
wesker
1GN Registrant


Age: 39
Joined: 10 Sep 2008
Posts: 64
Location: uniontown PA

1996 Dodge Neon

PostPosted: Wed Sep 10, 2008 8:00 am    Post subject: Reply with quote

i have a 01 motor with a 63 trim 12 psi turbo,a fpr set at about 40-45 psi,a 10:1 fmu and missing link,450cc injectors ,255 wabro pump,spoolboy modded cannister and return line,and a safc.is that a reasonable set-up?
Back to top
View user's profile Send private message Send e-mail  
DOHCRT
damnstupidshit
1GN Registrant


Age: 36
Joined: 03 Mar 2007
Posts: 1225
Location: Columbus, OH

1998 Dodge Neon R/T

PostPosted: Wed Sep 10, 2008 8:14 am    Post subject: Reply with quote

wesker wrote:
fpr set at about 40-45 psi,a 10:1 fmu and missing link,450cc injectors

Thats way to much base fuel pressure and way to high of a rate of gain for those injectors. You need about 10 - 20psi base fuel pressure with a rate of gain in the range of 4:1 to 6:1.
_________________
"Losers always whine about their 'best'. Winners go home and fuck the prom queen"

Project Log
Back to top
View user's profile Send private message  
wesker
1GN Registrant


Age: 39
Joined: 10 Sep 2008
Posts: 64
Location: uniontown PA

1996 Dodge Neon

PostPosted: Wed Sep 10, 2008 9:28 am    Post subject: Reply with quote

could that be why im smoking now.a guy on neon.org told me 49 psi on the fpr and a 10:1 fmu.im taking out this engine a putting a low,low mileage 95 motor in it.i want to do it right this time.
Back to top
View user's profile Send private message Send e-mail  
Ladi3sman55
Pt Ne (Elements)
1GN Registrant


Age: 26
Joined: 15 May 2007
Posts: 2892
Location: 51106

1998 Plymouth Neon

PostPosted: Wed Sep 10, 2008 12:33 pm    Post subject: Reply with quote

wesker wrote:
could that be why im smoking now.a guy on neon.org told me 49 psi on the fpr and a 10:1 fmu.im taking out this engine a putting a low,low mileage 95 motor in it.i want to do it right this time.


get a rebuild kit from modern
_________________


The definition of a NEON
A great domestic compact car whose rapidly disappearing taillights are most typically seen through the windshields of Honda Civics, Chevy Cavaliers, and other assorted shitboxes.
According to Urban Dict. dot COM
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
Display posts from previous:   
Post new topic   Reply to topic    1GN.ORG Forum Index -> Forced Induction All times are GMT - 8 Hours
Goto page 1, 2  Next
Page 1 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



smartDark Style by Smartor
Powered by p h p B B © 2001 , 2005 p h p B B Group
Protected by Anti-Spam ACP
1GN.org