Page 1 of 1

Need help

Posted: Fri Mar 30, 2012 4:04 pm
by neonfighter86
Ok then, I change my brake lines,brake hoses, all pads and rotors, all calipers,and now ive breed the brakes like 3x and there firm with the car off but as soon as u turn it on the car wont brake and have no pressure to the brakes, they just go strait to the floor im I doing something wrong[/list]

Posted: Sat Mar 31, 2012 10:17 am
by ricker91878
Try bleeding them with the car running otherwise you may have a bad line

Posted: Sat Mar 31, 2012 8:19 pm
by 1genRTturbo
i'd go with possible bad master.

Posted: Sat Mar 31, 2012 8:53 pm
by neonfighter86
But the master was good before the lines were replaced, im gravity bleeding them right now so im hoping there was air in the lines.

Posted: Sun Apr 01, 2012 9:30 pm
by neonfighter86
1genRTturbo wrote:i'd go with possible bad master.
does it matter if it has abs or not

Posted: Thu Apr 05, 2012 10:52 pm
by 1genRTturbo
yes it matters. abs is alot harder to have properly bled.

Posted: Thu Apr 05, 2012 10:58 pm
by neonfighter86
Finally got it, it was just a pain in the ass thanks guys.