60'............ 2.050
330'.......... 5.928
1/8th........ 9.180
MPH......... 77.46
1000'...... 11.983
1/4th...... 14.366
MPH........ 94.57
Test and Tune
All Motor
National Trail Raceway, Hebron (Columbus), Ohio
10/05/2007
I took the car to the truck scales just before racing; 2280 with a little less than 1/4 tank of fuel and no driver. The package shelf is gone, the hood only has enough bracing to hold the hinges, and the trunk lid is just the skin, officially it's now a beer can

I got in nine runs. The trans has been giving me trouble going into 2nd and 3rd. I finally figured out it's the shift cables, not the trans.
Under normal shift conditions it's fine 1-2 and 2-3, but on hard full power shifts it doesn't want to engage, causing missed shifts. If you put just a little pressure outboard on the 1-2 shift it's fine, full power. If you put a little extra outboard pressure the shifter for the 2-3 shift it's fine also. I think I need to slightly adjust the crossover cable.
All the 60's were 2.0XX's, 2.011 the best, 2.071 the worst, five were in the 2.05X range, two were 2.015's. Several of the ET's were crappy due to missed shifts. I figured out the shifter technique on the last two runs, netting the best time and a 14.430 @ 94.76.
My goal for the season was a sub 14.4. I'm really pleased.

It wasn't very cool last night so maybe there's a little more yet for the final Halloween Fri night event?
Is a sub 14.3 possible? I've got some timing gears, and a Crane MIS DIS coming form Ebay auctions. Maybe with just a 'lil tuning.....
I'd love a set of 18's for the last event, but the 18's won't be enough cam for the 2.4 I'll be building shortly. I'd need a SAFC, better valve springs and Wideband to make them run properly.
The head I have for the 2.4 already has Crane VS, PT lifters and rockers and a 3 angle valve job (thanks Vinny!) It wouldn't make sense to upgrade the current head just for one night. The final night might not even happen (weather).
The smartest/most cost effective idea would be to install the cam gears and bring it to the dyno for what ever gains could be had. I'd also like to know what power it makes with the stock motor.