PT front sway bar on a 1gen???
-
- 1GN Registrant
- Posts: 638
- Joined: Sun Mar 11, 2007 11:39 pm
- Location: Moro, Illinois
PT front sway bar on a 1gen???
A pt cruiser with a 24 mm front anti-sway bar came into the junk yard today. I plan on grabbing it tommarrow I was wondering if it fit a 1gn? I know it fits the 2nd gen neon
-
- 1GN Registrant
- Posts: 500
- Joined: Tue Nov 27, 2007 1:45 am
- Location: Cockeysville, Maryland
I'm a step ahead of you. The 2G/PT sway bars are wider than the 1G in both the front and rear. You will have to use a 2G k-frame as well, which do not have bobble strut brackets. So what do you do? You make one or buy one from www.polybushings.com and use a shadow/daytona bobble strut. The solid neon bobble strut is slightly wider than the early dodge cars, or you can get some thick washers in there. The 2G k-frame will bolt up, and that is of course a few inches wider than the 1G. That is my plan anyway.
- uta_flyinghigh
- 1GN Registrant
- Posts: 1423
- Joined: Fri Oct 05, 2007 6:26 am
- Location: Brighton, United Kingdom
- Contact:
-
- 1GN Registrant
- Posts: 500
- Joined: Tue Nov 27, 2007 1:45 am
- Location: Cockeysville, Maryland
The k-frame? The k-frame on a PT is slightly different than a neon. It has two lower mounting points, along with the same four the neon has. You want the k-frame or the 24mm front sway bar? There is only one at the yard, last time I was there.uta_flyinghigh wrote:How fast can you get it off a PT ?
UTA
- uta_flyinghigh
- 1GN Registrant
- Posts: 1423
- Joined: Fri Oct 05, 2007 6:26 am
- Location: Brighton, United Kingdom
- Contact:
-
- 1GN Registrant
- Posts: 500
- Joined: Tue Nov 27, 2007 1:45 am
- Location: Cockeysville, Maryland