Question about Pauter Rods

Have a question about how to make horsepower going the all motor route, here's where to ask it.
Post Reply
User avatar
Nono
1GN Registrant
Posts: 63
Joined: Mon Dec 03, 2007 7:39 pm
Location: San Juan, PR

Question about Pauter Rods

Post by Nono » Mon May 24, 2010 11:12 am

I bought this 2.4L engine with Pauter rods but it was already assembled when I got it. Due to crank issues, needed to take it off for some machine shop job (long story) but to put everything back, I have a problem... :shock: I dont know the torque specs for these rods.

Can anyone help me on this? Thanks in advance!!
-'98 SOHC Neon N/A
- Best 60' 2.04s, Best mph 98.87, Best e/t 13.99s - but
RIP !!!

- Finally.. in the end... Nono has joined the dark side. New project: 98 D♂hç ∩ε♂∩ ∩/a :twisted: :twisted: :twisted:

User avatar
DOHCRT
1GN Registrant
Posts: 1225
Joined: Sat Mar 03, 2007 12:34 pm
Location: Columbus, OH

Post by DOHCRT » Tue May 25, 2010 9:18 pm

http://www.pauter.com/blocknotch.htm

You can also call ARP's tech support if they are indeed ARP screws. I recommend the bolt stretch method if you have access to a stretch gauge. Bolt stretch is a more accurate way of tightening.
"Losers always whine about their 'best'. Winners go home and fuck the prom queen"

Project Log

Post Reply