Why don't more people use the 2.4 ecu and harness
- nuklhed074
- 1GN Registrant
- Posts: 136
- Joined: Wed Oct 21, 2009 8:28 pm
- Location: lima,OH harsville,TN
Why don't more people use the 2.4 ecu and harness
There has to be a downfall here I mean it's so much easier. You would not have to change any wires around, and the plugs are all the same, and the fuel would be right and you would not have to worry about injectors and fprs and lean conditions. [/u]
My sohc runs good mid 15s should i do dohc?
- 1genRTturbo
- 1GN Registrant
- Posts: 468
- Joined: Sun Feb 28, 2010 5:20 pm
- Location: Tooele, ut
the 2.4 harness needs a few changes, mostly because of the intake and position of the sensors. the pcm was ment for a lower reving and higher tourqe output. it is better to run a neon dohc harness and pcm so that your 2.4 can rev better. if its an n/a version they are way better.
It's not the fall that hurts, it's the sudden stop at the bottom!
- nuklhed074
- 1GN Registrant
- Posts: 136
- Joined: Wed Oct 21, 2009 8:28 pm
- Location: lima,OH harsville,TN
Alright well I'm going with the atx 2.4 harness and ecu so I will let you guys know what I think cause I am turning mine. Also what kinda changes we talking? I cause I would rather make smaller changes and my original harness was a hack job from the last guy that had car
My sohc runs good mid 15s should i do dohc?
- nuklhed074
- 1GN Registrant
- Posts: 136
- Joined: Wed Oct 21, 2009 8:28 pm
- Location: lima,OH harsville,TN